Filter
Top Products
SKU 93880 For technical questions, please call 1-800-444-3353 PAGE 10
8. CAUTION! Always use the Pipe Clamp assembly (56, 57, 58) to secure
and support the pipe during the threading operation. Make sure the Pipe
Clamp assembly (56, 57, 58) is securely clamping the pipe and that the pipe is
well supported while the threads are being cut. (See Figure G.) Also, the pipe
will need enough clearance to proceed through the die unimpeded.
9. Make sure the pipe end and threads of the Die (54, 54A, 54B, 54C) are sufficiently
oiled at all times. Otherwise, the life of the Die Blades (55, 55A, 55B, 55C) will be
shortened and the threads will be rough.
10. Located in front of the Power Switch (42) is a Rotation Direction Switch (41) which
determines the direction of the threading operation. Turn the Rotating Direction
Switch (41) to its right position for a clockwise rotation. (See Figure H.)
FIGURE G
PIPE CLAMP (56)
ROD (57)
NUT (58)
PIPE
FIGURE F
7. Insert the pipe into the rear of the Die (54, 54A, 54B, 54C). Make sure the
inside diameter of the Die matches the outside diameter of the pipe.
(See Figure F.)