Filter
Top Products
SKU 93880 For technical questions, please call 1-800-444-3353 PAGE 9
ASSEMBLY AND OPERATING INSTRUCTIONS
NOTE:
For additional information regarding the parts listed in the
following pages, refer to the Assembly Diagrams on pages 15 and 16.
1. CAUTION! Always make sure the Pipe Threader is disconnected from its
electrical outlet prior to assembling the tool, changing accessories, or performing
service to the product.
2. Wear ANSI-approved safety impact eye goggles and heavy duty work
gloves when using the Pipe Threader. Using personal safety devices reduce
the risk for injury.
3. Select the size of the pipe to be threaded (1/2”, 3/4”, 1”, or 1-1/4” diameters).
4. Select the appropriate Die (54, 54A, 54B, or 54C) to be used. NOTE: The Dies
are intended for use on standard schedule 40 and schedule 80 steel pipe.
(See Figure E.)
5. Insert the Die (54, 54A, 54B, 54C) into the Worm Gear (5) of the Pipe Threader.
The Die fits into the Worm Gear only one way. Make sure the Die is secured in
place before proceeding. The Die is pressure fitted so once it is inserted properly,
it may require light tapping with a wooden mallet to remove the Die.
(See Figure E.)
6. Make sure the accessory Oil Can (59) is filled with Thread Cutting Oil (not
included) and ready to be used during the threading operation.
DIE
(54, 54A, 54B, 54C)
DIE INSTALLED
FIGURE E