Filter
Top Products
SKU 93880 For technical questions, please call 1-800-444-3353 PAGE 13
TROUBLESHOOTING
6. When storing, make sure to store the Pipe Threader in a clean, dry, safe location
out of reach of children and other unauthorized people.
7. CAUTION! All maintenance, service, or repairs not mentioned in this
manual must only be performed by a qualified service technician.
four new Die Blades into the Die. NOTE: When inserting the Die Blades,
make sure the cutting edges of the Die Blades face
inward
. Also, make
sure the number on each Die Blade is at the
top
and in
sequence.
Once the
Die Blades are properly inserted, replace the Chrome Ring and four Screws.
(See Figure J.)
1
2
3
4
DIE
(54, 54A, 54B, 54C)
CHROME
RING
SCREWS
DIE BLADE
(55, 55A, 55B, 55C)
TOP VIEW
MAKE SURE
NUMBERS
ARE ON TOP
AND IN
SEQUENCE
FIGURE J
5. To clean: Use a mild detergent or mild solvent to clean the exterior of the Pipe
Threader and its Dies. Do not immerse the Pipe Threader in liquid.
Problem Possible Solution
Pipe Threader does not turn on. 1. Make sure the Power Switch is in its “ON” position.
(See page 11.)
2. Make sure the tool is connected to a working 120 volt,
grounded, electrical outlet. (See pages 6 and 7.)
3. Check Power Cord for damage.
4. Unplug Power Cord. Then remove Carbon Brushes and
check for wear and excessive debris. (See page 12.)
5. Have a qualified service technician check the tool for
damage and/or defects.
Pipe Threader does not turn off. 1. Unplug the tool from its electrical outlet, and have a
qualified service technician check for damage and/or
defects.
Pipe threads are rough and/or irregular. 1. Make sure to keep the pipe and Die well oiled
throughout the threading process.
2. Check the Die Blades for wear. If necessary, replace
the Die Blades. (See page 13.)
Rotating Direction Switch not working properly. 1. Have a qualified service technician check the tool for
damage and/or defects.
Difficulty in removing Die from Pipe Threader. 1. Use a wooden mallet to extract the Die.