Filter
Top Products
3. Assembling the Control Head to the Base and Handle
Inthisprocedureyouwillinstall thecontrolheadonto thebase assembly.
1. Insertthethumbknobboltthroughthepivotknuckleonthecontrolhead.
2. Alignthepivotknucklewiththemountarmsandslideintoplace,twisting
slightly if necessary, until theunit is firmly seated.
3. Rotate the control head to the desired angle and hand tighten the
thumbknob bolt.
4. Thread thegimbal knob onto the pivot bolt and tighten.
Pivot
Knuckle
GimbalKnob
Thumbknob
Bolt
Assembling theControl Head to the Base and Handle
GimbalKnob
Rear View Front View
4