Filter
Top Products
3. Connect the cables to the control head.
The slots for the plugs are keyed to
prevent reverse installation, and
insertion shouldbe easy.Donot to force
the connectors into the control head.
4. Pull the power cable through the
opening in the long side of the cable
well and insert it into the battery well
(see the illustration Installing the
Cables Onto the Base).
5. Route the transducer jumper cable (see the illustration Installing the
CablesOntotheBase)outthelongsideofthecablewellandfollowthe
arrowsonthebase.
6. Fit the transducer jumper cableconnector down into thejumper cable
wellandsnapit intoplace.Insert the two#6-32x 1/4" screwsincluded
tosecurethetransducer jumper connectorand tightenusing a Phillips
screwdriver.Hand tighten only!
Installing theCables Onto the Base
Transducer
Jumper
Cable
Screws
PowerCable
JumperCable Well
Connecting theCables to the Control Head
6