Filter
Top Products
System Status
Use System Status to view system connections and
to conduct a unit self-test.
The following screens are displayed in turn when
you press the VIEW button when using System
Status:
• Self Test
• Accessory Test.
Self Test displays results from the internal
diagnostic self test, including unit serial number,
Printed Circuit Board (PCB) serial number,
software revision, total hours of operation and
the input voltage.
NOTE: Your new unit may show many hours of
operation due to product testing performed at the
manufacturing facility.
Accessory Test lists the accessories connected to
the system.
NOTE: The speed accessory will be detected only if the
paddlewheel has moved since your FishFinder was
powered up.
Exit System Status by powering your FishFinder off.
Accessory Test Screen
System Status Self Test Screen
15
14
Simulator
Use the Simulator to learn how to use your FishFinder before taking your boat on the
water. The Simulator is a very powerful tool that simulates on the water operation,
providing a randomly-updated display. We recommend going through this manual
while using the Simulator, since all of the menus function and affect the display the way
they actually do when in Normal operating state.
NOTE: To get the full benefit of the Simulator, it is important to select Simulator manually from
the Start-Up Options menu as opposed to letting the FishFinder enter Simulator automatically (as
it will if a transducer is not connected and you do nothing during power up). Manually selecting
Simulator from the Start-Up Options menu allows you to pre-configure your FishFinder for on the
water operation. Any menu changes you make will be saved for later use.
A message will appear on the display periodically to
remind you that you are using the Simulator.
Exit the Simulator by powering your FishFinder off.
Simulator
FF585c_Man_English_531363-1_B.qxd 12/27/2004 8:33 PM Page 20