Filter
Top Products
When in an active function, a single press to an arrow button will result in a single incremental
adjustment. Pressing and holding an arrow button will sequence through a range of adjustments.
If no adjustment is made for 5 seconds, the unit will return to normal operation.
Shallow Alarm
The SHALLOW ALARM function can be set for depths ranging from 1 to 20 feet and sounds an
alarm when the depth is less than the setting.
From normal operation pressing SET once will display the SHALLOW ALARM setting and blink
the “SHALLOW” icon. The UP ARROW will activate the SHALLOW ALARM AND ALSO increase
the selected value. The DOWN ARROW will reduce the value. Hold the UP ARROW until you
reach the desired depth setting.
Note: The maximum SHALLOW ALARM setting can not meet of exceed the current DEEP
ALARM setting.
After your selection is made, the unit will return to normal operation after 5 seconds. The
‘SHALLOW’ icon should now be visible (figure 4).
If the depth of the water is less then the selected value, the alarm will sound and the “SHALLOW”
icon will blink to indicate the alarm. Pressing any button will mute the alarm; pressing SET will
mute the alarm and activate the SHALLOW ALARM function for additional adjustment. To
permanently turn the alarm off, use the DOWN ARROW to return the display to ‘OFF’.
Deep Alarm
The DEEP ALARM can be set for depths up to 99 feet and sounds an alarm when the depth is
greater than the setting.
Press SET until the DEEP ALARM function becomes active. This is indicated by the blinking
‘DEEP ALARM” and also increases the selected value. The DOWN ARROW will reduce the
value. Continue to press and hold the UP ARROW until you reach your desired value.
Note: The minimum DEEP ALARM setting cannot meet or go below the current SHALLOW
ALARM setting.
After your selection is made, the unit will return to normal operation after 5 seconds. The ‘DEEP”
icon should now be visible (figure 6).
If the depth of the water is greater than the selected value , the alarm will sound and the icon will
blink to indicate the alarm. Pressing any button will mute the alarm; pressing SET will mute the
alarm and activate the DEEP ALARM function for additional adjustment. To permanently turn the
alarm off, use the DOWN ARROW to return the display to “OFF”.
Units
The UNITS Control Function selects the UNITS of measure for depth readout and alarm
functions, The three settings available are Feet, Meters or Fathoms.
Press SET until the UNITS function is activated on-screen. This is indicated by the blinking
UNITS icon. Pressing either arrow will allow you to select from the choices. Continue to press an
arrow until the desired readout is selected; FT for feet, M for meters, FA for fathoms.