Filter
Top Products
10
5
MEMORY PROGRAMMING
■ Memory names
ïProgramming memory names
qSelect the memory channel to be programmed:
➥Push [V/M] to select memory mode.
➥Push [Y] or [Z] to select the memory channel.
wPush [M/W] for 5 sec. to enter memory name writing mode.
•The first character of the name flashes.
ePush [SCAN] or [SQL] as many times as necessary to
enter the desired name.
•To erase a character, overwritet with a space (displayed as _).
•To move the cursor forwards or backwards, use [Y] or [Z].
•Push [
] for 2 sec. to erase all characters.
rPush [M/W] to input the set name.
•Flashing stops.
•Memory channels can be programmed with names of up to 5
characters in length.
•When no name is programmed, the display shows the operating
frequency.
•The following characters can be used in names:
➥0 to 9, A to Z (capitals), (space), “-”, #, $, &, (, ), “,”, •, /,
<, >, =, “, ‘, ?, ! and @.
MR
MR
MR
[EXAMPLE]: Setting the name to “TOWER”.
SCAN
+
MW
MW
SQL
or
or
MR
for 5 sec.
for 2 sec.
IC-A4#01 IM 01.12.5 5:14 PM Page 10 (1,1)