the following points before sending it to a service center.
POSSIBLE CAUSE SOLUTION REF.
No power comes on. • The battery is exhausted.
• Bad connection to the battery pack.
• Recharge the battery pack.
• Check the connection to the
transceiver.
pgs. 12,
14
No sound comes from the
speaker.
• Squelch level is too deep.
• Volume level is too low.
• Set squelch to the threshold point.
• Set [VOL] to a suitable level.
pgs. 5, 6
Transmitting impossible. • Some channels are receive only.
• The battery is exhausted.
• Change channels.
• Recharge the battery pack.
p. 5
p. 12
The displayed channel
cannot be selected.
• Lock function is activated.
• Push for 2 sec. to cancel the
function.
p. 6
Scan does not start. • All memory channels are programmed
as lockout channels.
• Cancel the lockout settings of
desired channels.
p. 9
No beep sounds. • Beep tones turned OFF. • Turn the beep tone ON in set mode. p. 11
PROBLEM
