Filter
Top Products
3
BASIC OPERATION
9
■ Call channel programming
The call channel switch can be programmed to your most
often-used channels in each channel group for quick recall.
q While pushing and holding [HI/LO], push [DIAL] one or
more times to select the desired channel group (Interna-
tional, U.S.A., Holland, ATIS, DSC) to be programmed.
w Push and hold [CALL] for 3 sec. to enter the call channel
programming condition.
•Channel number starts flashing.
e Rotate the channel selector to select the desired channel.
r Push [CALL] to program the displayed channel as the call
channel.
•Push [DIAL] to cancel the programming.
•The channel number stops flashing.
■ Channel names
Memory channels can be tagged with alphanumeric names
of up to 10 characters each.
Capital letters, small letters, numerals, some symbols (! " # $
% & ' ( ) ✱ +
,
–
.
⁄) and spaces can be used.
q Select the desired memory channel.
•Cancel dual watch, tri-watch or scan in advance.
w While pushing and holding [HI/LO], push [CALL] to edit the
memory channel name.
•A cursor appears and blinks.
e Select the desired character by rotating the channel selec-
tor or by pushing [Y]/[Z] on the microphone.
•Push and hold [SCAN] or [DIAL] for cursor movement.
r Push [CALL] to input and set the name.
•The cursor disappears.
t Repeat steps q to r to program another memory channel
name, if desired.
INT
25W
TAG
äLEASURE
INT
25W CALL
DUPTAG
INTL
INT
25W CALL
TAG
CALLING
01 IC-M503-(1).qxd 01.12.17 5:00 PM Page 9 (1,1)