Filter
Top Products
31
12
HM-134 REMOTE-CONTROL MICROPHONE
➥In set mode, indicates the selected condition. (pgs. 14,
37)
r VOLUME INDICATOR (p. 33)
Appears while audio output level is adjusted.
t SQUELCH INDICATOR (p. 33)
Appears while noise squelch level is adjusted.
y CHANNEL NAME INDICATOR
➥Channel comment appears (and scrolls) if programmed.
(pgs. 9, 38)
➥In set mode, indicates or scrolls the selected set mode
item. (pgs. 14, 37)
u SCRAMBLER INDICATOR (pgs. 10, 35)
Appears when an optional voice scrambler is activated.
i SCAN INDICATOR (pgs. 13, 36)
➥“SCAN” appears during normal scan.
➥“P SCAN” appears during priority scan.
o PRIORITY CHANNEL INDICATOR
➥Indicates a priority channel during priority scan or
dual/tri-watch. (pgs. 12, 36)
➥“IC” appears during intercom mode. (pgs. 17, 38)
!0 DUAL/TRI WATCH INDICATOR (pgs. 11, 36)
“DUAL” appears during dualwatch;“TRI” during tri-watch.
!1 LOW POWER INDICATOR (pgs. 8, 33)
Appears when low power is selected.
!2 CALL CHANNEL INDICATOR (pgs. 6, 32)
Appears when the call channel is selected.
!3 DUPLEX INDICATOR (pgs. 6, 32)
Appears when a duplex channel is selected.
!4 TAG CHANNEL INDICATOR (pgs. 13, 36)
Appears when a tag channel is selected.
!5 BUSY INDICATOR (pgs. 8, 33, 34)
Appears when receiving a signal or when the squelch
opens.
!6 TRANSMIT INDICATOR (pgs. 8, 33)
Appears while transmitting.
!7 “WAIT” INDICATOR
“WAIT” appears in the HM-134 display while transmitting
via the IC-M503’s attached microphone.
•In the above case, the connected HM-134 does not have prior-
ity.
01 IC-M503-(1).qxd 01.12.17 5:00 PM Page 31 (1,1)