Filter
Top Products
6
SET MODE
14
Push
16
Beep tone
Beep
ATIS check
ATIS check
Scan mode
Scan mode
Scan resume timer
Scan timer
Dual/tri watch
DUAL/TRI
LCD contrast
LCD
contrast
Internal speaker
Internal
speaker
Scrambler code
Scrambler
code
Scrambler type
Scrambler
type
■ Set mode programming
Set mode is used to change the conditions of the trans-
ceiver’s functions: scan mode (normal or priority), scan re-
sume timer, dualwatch/tri-watch selection, beep tone function
(transceiver or HM-134), internal speaker (transceiver or HM-
134), LCD contrast (transceiver or HM-134), scrambler code,
scrambler type and ATIS check.
•Available functions may differ depending on dealer set-
ting.
•The optional HM-134 has it’s own settings for the beep
tone, internal speaker and LCD contrast.
q Turn power OFF.
w While pushing and holding [16], turn power ON to enter set
mode.
e After the display appears, release [16].
r Push [16] to select the desired item, if necessary.
t Rotate the channel selector to select the desired condition
of the item.
y Turn power OFF, then ON again to exit set mode.
•SET MODE CONSTRUCTION
01 IC-M503-(1).qxd 01.12.17 5:00 PM Page 14 (1,1)