Filter
Top Products
11
BASIC OPERATIONS
SWITCHING POWER ON/ OFF
Press the switch to switch the transceiver ON.
•A beep sounds and the display momentarily lights up.
• If the Transceiver Password function is programmed, “PASSWORD” appears on the
display. You must enter the password to unlock the transceiver. Refer to “Transceiver
Password”, below.
Press and hold the switch for approximately 1 second to switch the transceiver
OFF.
■ TRANSCEIVER PASSWORD
To enter the password:
1 Rotate the CH control to select a digit.
2 Press the GRP key to accept the entered digit and move to the next
digit.
3 Repeat steps 1 and 2 to enter the entire password.
• The password can contain a maximum of 6 digits.
• Press the PF 3 key (the third key from the left, after the CH control) to delete an
incorrectly entered character. Press and hold the PF 3 key to delete all
characters.
4 Press the PF 2 key (the second key from the left, after the CH control) to
confirm the password.
• If you enter an incorrect password, an error tone sounds and the transceiver
remains locked.
To enter the password using a DTMF keypad:
1 Press the DTMF keys corresponding to the password digits.
• The password can contain a maximum of 6 digits.
• Press the PF 3 (the third key from the left, after the CH control) or DTMF # key
to delete an incorrectly entered character. Press and hold the PF 3 or DTMF #
key to delete all characters.
2 Press the PF 2 or DTMF key to confirm the password.
• If you enter an incorrect password, an error tone sounds and the transceiver
remains locked.
ADJUSTING THE VOLUME
Rotate the VOL control clockwise to increase the volume and counterclockwise
to decrease the volume.