Filter
Top Products
32
• Speaker 1 – 2 Mute
Press this key to mute the secondary speaker when using a dual-head
system. The Head 1 speaker will mute when pressing this key from the Head
2 unit, and the Head 2 speaker will mute when pressing this key from the
Head 1 unit.
• Squelch Level
Press this key to adjust the transceiver squelch level. When adjusting the
squelch level, use the the GRP and keys or the CH control to increase
and decrease the squelch level.
The squelch level can be adjusted from 0 (open) to 9 (tight). The default
setting is 5.
• Status
Press this key to enter Status mode. Press and hold this key to enter Stack
mode. Refer to “FleetSync: ALPHANUMERIC 2-WAY PAGING FUNCTION”
on page 17 for details.
•Tactical Group
Press and hold this key for 1 second to register the selected channel as a
Tactical Group channel. Press and hold this key for 3 seconds to register all
channels within the current zone as Tactical Group channels.
•Talk Around
Press this key to toggle Talk Around ON and OFF. When activated, “TA”
appears on the sub-display.
While using Talk Around, you free up the repeater and communicate directly
to other transceivers that are within range. If the other party is too far away,
you must continue to use the repeater to engage in communication.
•Talkgroup
Press this key to select the Group ID list. You can then select the ID of the
group you want to call. Refer to “MAKING GROUP CALLS” on page 12 for details.
•Tone
Press this key to turn the transceiver audible tones off. When active, you will
no longer hear tones from the transceiver. Press this key again to turn the
audible tones back on.
• Zone Down
Press this key to decrease the zone number. Press and hold this key to cycle
down through the zone numbers. If programmed by your dealer, when the
lowest zone number is reached, the transceiver will “roll-over” to the highest
zone number and continue cycling down.
• Zone Select
Using the CH control, turn clockwise to increase the zone number and
counterclockwise to decrease the zone number.
• Zone Up
Press this key to increase the zone number. Press and hold this key to cycle
up through the zone numbers. If programmed by your dealer, when the
highest zone number is reached, the transceiver will “roll-over” to the lowest
zone number and continue cycling up.