Filter
Top Products
25
Edit mode
In this mode you can turn each effect on/off,
and edit the effect type, parameter values, and
program name.
In Play mode, press the √ (or ®) button to
access the DYNA effect edit screen.
In any screen of Edit mode, you can use the
control knobs to edit the tone and level, or use
the TAP button to set the delay time.
Press the EXIT button to re-
turn to Play mode.
If a program was not written af-
ter it was edited, the decimal
point of the program number will
light.
The edited settings will return to the settings
of the original program if you switch programs
or turn off the power without Writing (see p.28).
1.Select the effect that you wish to edit
Each time you press the √/® buttons, you will
cycle through the effects in the order shown be-
low. When an effect is selected, its icon will blink.
2.Editing each effect
For each effect, you can select the effect type
and set its parameter values.
Effects that are turned “OFF” will automatically
be turned “ON” if you press the ENTER/REC but-
ton or use the ▲/▼ buttons to select the effect
type.
For details on the effect types and parameters,
refer to Effect Parameters (p.31). Renaming the
program and writing the program are also per-
formed here.
Before
writing
After
writing