Filter
Top Products
Navigator User Guide
38
• To respond to a Direct Page when Handsfree Answerback is OFF, see Direct Paging –
Handsfree Answerback Disabled.
Note: By default, Handsfree Answerback is turned OFF at your phone. If the (MUTE) key
is OFF when your set is idle, Handsfree Answerback is OFF.
To answer a call using Handsfree Answerback, see Table 4:
Table 4: Answering a Direct Paging Using Handsfree Answerback
Phone state before the
Direct Page arrives
To answer the Direct Page
Phone is idle, and (MUTE)
is flashing
1. Check that
(MUTE) is OFF.
2. Listen for the paging party.
3. Speak to the paging party.
4. Lift the handset if you wish to switch from a Handsfree
call to a handset call.
You are on a handset or
headset call, and
(MUTE)
is OFF
1. Check that
(MUTE) is flashing.
2. Press
(MUTE).
The light turns ON solid, and you are now speaking to the
paging party and have muted your handset/headset call.
3. Speak to the paging party.
4. Press
(MUTE) to alternate between handset/headset
and handsfree calls.
You are on a MUTED
handset/headset call, OR, you
are on a Handsfree call
• The party paging you receives a busy tone. Handsfree
Answerback does not interrupt your call.
To end a Handsfree Answerback call, do one of the following:
• Hang up the handset, if you switched to a handset call.
• Press
(SPEAKER).
• Press
(CANCEL).
Note: When the Handsfree Direct Page call ends, the (MUTE) key light returns to the
state it was in before the call was established.
Direct Paging – Handsfree Answerback Disabled
Your administrator enables or disables Handsfree Answerback on your phone. You may also turn
Handsfree Answerback off on your phone, even after your administrator has enabled it. To turn
Handsfree Answerback off, see Direct Paging – Handsfree Answerback Enabled.