Filter
Top Products
Navigator User Guide
39
When Handsfree Answerback is disabled or turned off on your phone and you receive a Direct
Page, the Direct Page is indicated by a single burst of tone. If your PC headset is plugged in, the
Direct Page tone sounds in your headset earphones and you can answer using your headset.
To answer a Direct Page when Handsfree Answerback is disabled, see Table 5.
Table 5: Answering a Direct Page with Handsfree Answerback Disabled
Phone state before the
Direct Page arrives
To answer the Direct Page (indicated by a single burst of tone)
Phone is idle, and (MUTE)
is OFF
1. Check that
(MUTE) is ON solid.
2. Lift the handset
or
3. Press
(MUTE) to answer in Handsfree mode.
(The light turns OFF.)
4. Speak to the paging party.
You are on a handset or
headset call, and
(MUTE)
is OFF
1. Check that
(MUTE) is flashing.
2. Press
(MUTE).
The light turns ON solid, and you are now speaking to the
paging party and have MUTED your handset/headset call.
3. Speak to the paging party.
4. Press
(MUTE) to alternate between handset and handsfree
calls.
You are on a MUTED
handset/headset call, OR, you
are on a Handsfree call
• The party paging you receives a busy tone.
Handsfree Answerback does not interrupt your call.
To end a Direct Page call, do one of the following:
• Hang up the handset to end a handset call.
• Press
(SPEAKER) to end a handsfree call.
• Press
(CANCEL).
Note: When the Handsfree Direct Page call ends, the (MUTE) key light returns to the
state it was in before the call was established.
Record a Call
This feature uses your voice mail system to record your phone conversations.
Note: You may be required by law to inform the other party that you are recording the
conversation. For specific instructions, consult your system administrator.