Filter
Top Products
8
RE-ARMING YOUR
INFLATABLE PFD
To re-arm your PFD, you will
need Mustang Survival's Re-Arm
Kit MA5183, which includes the
Inflator Removal Key (A), the
Inflator Body & Cylinder (B), and
the Inflator Cap & Pull Handle (C)
(Fig. 9).
1. Check that the status indicator
is green on both the cap and
body. If not green, you will be
unable to re-arm.
2. Place your PFD on a flat
surface so that the inflator is
facing up and wipe off any
water. Pass the pull handle
back through the button hole
so it is on the same side as the
inflator.
3. Insert the Inflator Removal Key
between the yellow inflator cap
and the black locking ring
(Fig. 10), and turn counter
clockwise. The black ring will
rotate counter clockwise behind
the yellow inflator cap (Fig. 11).
4. Turn the black locking ring
fully counter clockwise and
pull the inflator cap off the
bladder (Fig. 12, Fig. 13).
Discard.
5. Squeeze the sealing ring to
elongate and remove the black
inflator body and cylinder from
inside the bladder (Fig. 14).
Discard (Fig. 15).
Status Indicator
A
B
C
FIG. 9
Locking Ring
Key
FIG. 10
FIG. 11