Filter
Top Products
ND-70684 (E) CHAPTER 1
Page 7
Revision 1.0
OVERVIEW
DSS/BLF
3. Multiple D
term
s cannot use one DSS console.
4. Circuit cards for the DSS are as follows:
• PA-16ELCJ
• PA-DAIG-A (DAI)
• PA-DAIJ-A (DAI)
The previous conditions also apply when a Distributed Access Unit (DAU) is used between the PBX and the
DSS.
6. DSS/BLF
One DSS/BLF console requires 2 consecutive ports on an ELC/DAI card.
When a DSS console is used as a DSS/BLF, be sure to assign and wire the DSS/BLF to a specific LEN whose
level (LV) is an even number (LV = 0, 2, 4, 6). Since a DSS/BLF requires 2 consecutive ports to program the
DSS keys, the port following the designated port, to which the DSS/BLF is wired, must be reserved.
Note:
In Table 1-4, “n” represents 0, 1, 2, 3.
Table 1-4 Level Assignment Conditions for DSS/BLF
LEVEL NUMBER CONDITIONS
2n A DSS console can be connected.
2n + 1 Must be reserved for the DSS console.