Filter
Top Products
CLASSIFICATION
Einstufung
No.
DS-Eval4570-2400
REV.
C
SUBJECT
Thema
EvalBoard PAN4570
PAGE
Seite
8 of 20
CUSTOMER’S CODE
EvalPAN4570
PANASONIC’S CODE
DATE
Datum
06.11.2006
European Technology Center
Panasonic Electronic Devices (EUROPE) GmbH
APPROVED
genehmigt
CHECKED
geprüft
DESIGNED
Erstellt
6. SERIAL PORT
The evalboard is equipped with a serial port connector, which is linked to UART1 (SCI1)
of EM250. The S1 switch has to be set as follows:
UART1
active
1 2 3 4 5 6 7 8
S1
settings
ON
off
ON
off off off off off
(Table 3)
7. RESET
Reset of the boards on A,B,C or D can be done with the button named “RESET” next to
the USB socket.
8. OPERATION AND PROGRAMMING
8.1. SERIAL COMMUNICATION AND EMBEDDED BOOTLOADER
As a first step connect the testboards with the serial cables to 1 or 2 pc´s running
terminal programs (for example Hyperterminal) with the following communication
settings:
115200bps,8,parity no, Stoppbits 1, no flow control
After a hardware RESET and hitting the >return< key the terminal window of the PC
connected to the RS232 interface of the ISM RF transceiver testboard should display
Ember Range Test Application v2.0
Oct 1 2006
Set to channel 0x0F
In order to do testing of basic hardware performance you could now proceed with
commands described in chapter 9.4
. If you would like to run other applications, you
could load an image file to PAN4570 as well. The chapter 0 describes loading the
>simple-lighting< application from EmberZNet 2.5.0.
Launch the embedded bootloader typing in >bootload< and press the. The display now
should read
EM250 Bootloader v20 b01
1. upload ebl
2. run
3. ebl info
>BL
Typing in >2< and hitting the >return< key would result in running the Ember
TM
Rangetest
software again.