Filter
Top Products
14 C2473M-C (8/06)
Figure 9. RS-422 (D or P Protocol) Controller with UTP Video – Point-to-Point Configuration
NOTES:
• Input power for the IPS-RDPE-2 is 24 VAC only. The maximum wire gauge allowed for power input and output is 12 AWG.
• The maximum wire gauge allowed for UTP is 16 AWG.
• Refer to the manual supplied with the back box for wiring distances and coaxial cable requirements.
UTP RECEIVER
AT CONTROL SYSTEM
VC-UTPPOSITIONING SYSTEM
TX+ TX- RX+ RX-
POWER
24 VAC+
24 VAC-
24 VAC+
24 VAC-
RX- RX+ TX- TX+
UTP- UTP+
RX- RX+ TX- TX+
UTP- UTP+
UTP- UTP+
UTP- UTP+
IPS-RDPE-2
CONTROL SYSTEM
TX- TX+ RX- RX+
TO
POWER
SUPPLY
PTZ CONTROL AND
SOFTWARE UPLOAD