Filter
Top Products
INSTALLATION
OVERVIEW
MAINTENANCEOPERATION
Determine appropriate indoor location of
the power supply and chamber, referring
to Dimensions and Layout drawing.
Power supply should be installed higher
than chamber away from all water
sources. Ensure adequate clearance
above chamber to allow for removal of
the lamp and sleeve.
Insert chamber and
tighten clamp(s).
Screw chamber clamp(s) to the wall (#10
screws recommended.)
4
1
3
2
105
6
7
8
9
Install power supply mounting bracket to
wall using four #8 screws (not provided).
Make all necessary plumbing
connections referring to Dimensions and
Layout drawing.
Safety cap, lamp plug and power supply
figures will look slightly dif
ferent than
those on your system.
INSTALLING THE UV SYSTEM
Slide
Reference
card behind
power
supply.
Slide power
supply onto
mounting
bracket.
Align connections
by rotating
ring clamp (if
equipped) to
push lamp plug
onto end of lamp.
ring
clamp
Insert Lamp/
sleeve assembly
and screw into
chamber.
Caution: Over
tightening will
break the sleeve.
1
2
WARRANTY
9