Filter
Top Products
GX1280S Page 29
5. To start scanning, press the
[
SCAN
]
key. Scan-
ning will proceed from the lowest to the highest
programmed channel number and will stop on a
channel when a transmission is received.
6. The channel number will blink during reception.
7. To stop scanning, press the
[
SCAN
]
,
[
16/9
]
,
[
WX
]
,
[
CALL/SET
]
, or PTT
key.
6.16 PRIORITY SCANNING
(
P-SCAN
)
1. Channel 16 is set as the priority channel and cannot be changed.
2. To select priority scanning, press the
[
SCAN
]
key
to start memory scanning (“M-SCAN” will appears),
then press and hold down the
[
SCAN
]
key until
“P-SCAN” appears on the LCD. Scanning will pro-
ceed between the memorized channels and the priority channel. CH 16
the priority channel will be scanned after each programmed channel.
MEM CH. CH. 16
CH. 70 MEM CH. CH. 16
CH. 70
3. To stop scanning, press the
[
SCAN
]
,
[
16/9
]
,
[
WX
]
,
[
CALL/SET
]
, or PTT key.
NOTE
Triple watch (T/W) means the radio is watching CH70 for DSC Calls.
Dual watch (D/W) means the radio is not watching CH70 for DSC Calls.
6.17 NAVIGATION INDICATION
The transceiver has the ability to display the time, SOG and COG date, as
well as the vessel’s position (LAT/LON), when connected to a GPS receiver.
1. Press and hold the
[
H/L
]
key to display position
information. If the GPS receiver is not receiving a
fix, the display will be as shown in the illustration
on the right.
2. To hide the position information, press the
[
H/L
]
key.