Filter
Top Products
Page 21Phantom PS2000
KEY PAD
[
SCAN
]
Key
Starts and stops scanning of programmed channels.
If held while the
[
]
or
[
]
key is pressed, the radio will show the
channels programmed in scan memory. This function will not work if
the unit is scanning.
NOTE: The priority channel by default is Channel 16, however the
priority channel can be changed. To select a different priority channel
refer to section “12.8 SCAN TYPE.”
[
CALL
(
SET
)
MENU
]
Key
The
[
CALL
(
SET
)
MENU
]
key functions as the enter key.
Secondary use
Press the
[
CALL
(
SET
)
MENU
]
key to access the DSC OPERATION menu.
The “INDIVIDUAL CALL,” “GROUP CALL,” “ALL SHIP CALL,” “POSI-
TION REQUEST,” POSITION SEND,” STANDBY MODE,” and “CALL
WAITING” functions can be accessed from the DSC OPERATION menu.
Press and hold the
[
CALL
(
SET
)
MENU
]
key to access the RADIO SETUP
(refer ro section “8. ) or DSC SETUP menu (refer ro section 7).
[
DW
(
IC
)]
Key
Watches for a transmission on CH16 and another selected channel until
either signal is received. (Dual watch)
Secondary use
Press and hold the
[
DW
(
IC
)]
key, intercom operation will operate be-
tween the two CMP25 RAM+ Microphones, if installed.
[
NAV
]
Key
Press the [NAV] key, when connected to the GPS receiver, the LCD dis-
plays Position Information or Cruise Information from the GPS.
Secondary use
Press and hold the
[
NAV
]
key to access PA/FOG function menu.
[
WX
]
Key
Immediately recalls the previously selected US NOAA weather channel
from any channel location.
Secondary use
Holding down the [16/9] key while pressing the [WX] key switch the Chan-
nel Group.
[
DISTRESS
]
KEY
Used to send a DSC Distress Call. To send the distress call refer to section
“11.3.1. Transmitting a DSC Distress Call.”