Filter
Top Products
Instruction Manual
8
Load default setting
On this page, you can load and store the factory default settings into EEPROM.
NOTE: Network settings and MAC address will not be changed.
Press “Load” to load default settings. Reset the device to take eect.
Firmware update
On this page, you can update the rmware via Ethernet.
WARNING! Pressing the ‘Load’ button will immediately erase the ash with no
further warning
1. Pressing the “Load” button will erase ash.
2. Wait for erase process to complete.
3. There are two methods to do the Firmware Update action (TFTP or Web):
NOTE: Please avoid loss of network connection, power or other interruption during
the rmware upgrade procedure
Web
a. Please type in or browse the target image le in the input eld, and then press
“update” button to continue.
TFTP
a. Use Windows Command Prompt window to run the tftp client program.
Syntax: tftp -i 10.1.1.1 put FILE_DIRECTORY\FILENAME.bin
b. The rmware update should take about 45 seconds to complete.
c. If the update process somehow goes wrong (like power failure), please connect
to http://10.1.1.1 to try and restart the process (you may have to reset the
device rst)