Filter
Top Products
Remote Proportioning Valve Chapter 2: Safety 9 of 30
2-3 Warnings and Precautions
The installation, operation and maintenance of this equipment is to be conducted in
accordance with all applicable work and safety codes for the location where it is used. This
may include, but is not limited to, OSHA, NEC, CSA, SPI, and any other local, national, and
international regulations. In addition, the following specific work rules must be observed:
; Always keep these operating instructions on hand, and follow them when performing
installation, operation, and maintenance procedures. If the instructions become
damaged or unreadable, additional copies may be obtained from the manufacturer’s
Parts Department.
; Only qualified personnel can work on or with this equipment.
; Work only with approved tools and devices.
; The electrical power and compressed air must be disconnected when performing
maintenance or service. If the unit is installed with a power cord that can be
unplugged, be sure to unplug it. If the unit is permanently wired to a power main, a
fused power disconnect must be installed to allow the disconnect to be locked in the
“OFF” position. It is advisable to remove the disconnect fuses and carry them with
you.