Filter
Top Products
Chapter 5: Advanced Serverboard Setup
5-23
SCSI Controller Enable/
Disable (H8DMR-82 only)
Jumper JPA1 is used to enable or dis-
able the onboard SCSI controller. The
default setting is on pins 1-2 to enable
SCSI. See the table on right for pin
defi nitions.
SCSI Enable/Disable
Jumper Settings (JPA1)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
SCSI Termination Enable/
Disable (H8DMR-82 only)
Jumpers JPA2 and JPA3 are used to
enable or disable termination for the
SCSI Channel A and B connector, re-
spectively. The default setting is open
to enable termination. See the table on
right for pin defi nitions.
Note: In order for the SCSI drives to
function properly, please do not change
the default setting (enabled) set by the
manufacturer.)
SCSI Term. Enable/Disable
Jumper Settings (JPA2, JPA3)
Jumper Setting Defi nition
Open Enabled
Closed Disabled
Compact Flash Master/
Slave
The JCF1 jumper allows you to as-
sign either master or slave status to
a compact fl ash card populating the
JIDE1 slot . See the table on the right
for jumper settings.
Compact Flash
Master/Slave
Jumper Settings (JCF1)
Jumper Setting Defi nition
Closed Master
Open Slave