Filter
Top Products
6. Adjust the blinking PO
2
(oxygen partial pressure) value with
[DOWN] or [Up] and confirm with [SELECT].
7. Adjust other mix settings as needed.
8. Press [MODE] to exit.
NOTE: If the oxygen content of a mix is set to 22% or above,
the setting value remains until changed. It does not automatically
revert back to 21%.
Changing gases
When more than one gas mix is defined you can change between
the defined mixes during a dive.
1.
While in Nitrox mode, keep [DOWN] pressed.
2.
Press [SELECT] to enter the
Nitrox
setting.
3.
Scroll to
Mix1
,
Mix2
or
Mix3
as desired using [UP] or [DOWN]
and press [SELECT] to select the desired mix.
4.
Define the selected mix as
Primary
,
Secondary
or
Off
with [UP]
or [DOWN] and confirm with [SELECT].
53.6
Mix1
Primary
5. Adjust the blinking O
2
value with [DOWN] or [UP] to match the
oxygen % of your tank and accept with [SELECT].
41