Filter
Top Products
6. Adjust the blinking PO
2
(oxygen partial pressure) value with
[DOWN] or [Up] and confirm with [SELECT].
7. Adjust other mix settings as needed.
8. Press [MODE] to exit.
The gas mixes may be tagged as Primary, Secondary or Off. One of
the gases is always set as Primary and the other gases may have any
status. The decompression calculation is based on mixes that are
defines as Primary gases.
NOTE: It is only possible to change to another gas mix if the gas
is within the set maximum oxygen partial pressure limit.
3.13.3 Gauge mode
With Gauge mode, you can use Suunto Vyper Novo as a bottom
timer.
The timer in the center of the display shows dive time in minutes
and seconds and activates at the start of the dive. The total running
dive time, in minutes, is in the lower right corner.
The timer in the center of the display can be used as a stopwatch by
pressing [SELECT] during the dive.
Pressing [SELECT] resets the main timer and adds a bookmark to the
dive log. The previously-timed interval is displayed below the main
timer.
42