Uniden UM380BK Marine Radio User Manual


 
14
English
Follow the steps below to edit the list of FIPS codes. You can store up to 30 different FIPS
codes in your radio.
Display the normal menu and choose the Setup sub-menu.
1. Select FIPS Codes. The screen displays any previously-entered FIPS codes.
2. To add a new FIPS code, select New.
3. Use
CHANNEL UP
and
CHANNEL DOWN
to change the first of the six digits;
CHANNEL UP
increases the number and
CHANNEL DOWN
decreases it.
4. When the first digit is correct, press
ENT-1W/25W
. The cursor moves to the next digit. Enter
the remaining five digits of the FIPS code in the same way. If you make a mistake while
entering a digit, press
CLR-SCAN
to erase the wrong number and moved the cursor to the
left digit.
5. When the sixth digit is correct, press
ENT-1W/25W
. The radio displays the new FIPS code
and asks you to confirm. To save this code, select Yes; to cancel this code, select No. The
radio returns to the list of FIPS codes.
6. To change an existing FIPS code, select the code you want to change.
7. To delete the FIPS code, select Delete. To edit the code, select Edit, then use
CHANNEL UP
and
CHANNEL DOWN
buttons to change each of the six digits.
8. When you are satisfied with the list of FIPS codes, select Exit to close the menu screen.

Contrast
Your radio display has 10 levels of contrast. To adjust the contrast, press and hold
CALL-MENU
while the radio is idle. Select System and then Contrast. Use
CHANNEL UP
and
CHANNEL DOWN
to
change the contrast to your desired level.
To restore the default contrast setting, turn the radio off. Press
CALL-MENU
and hold it in while
you turn the radio on.
Lamp adjust
Your radio has 10 brightness levels on the display. To adjust the brightness, press and hold
CALL-MENU
while the radio is idle. Select System and then Lamp Adjust. Use
CHANNEL UP
and
CHANNEL DOWN
to change the brightness to your desired level.
Turning the key beep on and o
Key beep is the tone that sounds when you press a key or a button. To turn off the key beep,
press and hold
CALL-MENU
while the radio is idle. Select System and then Key Beep. Choose Off
to turn off the key beep.

You will see different display messages on your radio depending on what state your radio is
in. Refer to the following table for a description of what displays according to what condition
000000
Use the up and down arrows
to adjust each of the six
digits in turn.
16
FIPS Code
Back[CLR]
Forward[ENT]
FIPS Codes
Setup
Press and hold -
[New]