Filter
Top Products
975-0525-01-01 17
Operation
Restarting After an AC Output Shutdown
1. Press and hold the unit’s power switch button to turn it Off.
2. Remove all AC loads or let the unit cool down for 15 minutes.
3. Press and hold the unit’s power switch button to turn it On.
Changing the Audio Alarm Setting
1. Press and hold the power switch button for five seconds.
NOTE: You will hear a beep after holding the button for about
one second. Keep holding the button for five seconds more to
change the alarm setting.
2. Observe the message on the digital display.
If you see a.L.1. being displayed, this indicates that the audio
alarm is enabled even during warning conditions. If you see
a.L.0. being displayed, this indicates that the audio alarm is
disabled.
NOTE: Factory setting is a.L.1. .
3. Release the button to which setting you want.
NOTE: Holding the power switch button continuously for more
than five seconds at a time will cycle the alarm setting to a.L.1
then to a.L.0 and so on until the button is released.
Operating Limits
Power Output
The PROwatt SW will deliver the following power continuously,
depending on input voltage and ambient temperature. The inverter
will deliver more than 10% of its continuous power rating for
approximately five minutes.
Model Power
a
a.Applies to resistive loads such as incandescent lights.
Current
b
b.Applies to reactive loads such as motors.
Voltage Temp.
PROwatt SW 700i 700 W 3 A
12.5 Vdc
Ambient
25 °C
(77 °F)
PROwatt SW 1400i 1400 W 6 A
PROwatt SW 2000i 2000 W 8.7 A
PROWatt SW Inverter International.book Page 17 Tuesday, June 30, 2009 9:58 AM