Filter
Top Products
Operation and handling requirements
53
(3) Remove the dipstick and wipe it clean.
(4) Insert the dipstick back into the dipstick
tube completely. Remove the dipstick
again and make sure that the engine oil
level is between the minimum and maxi-
mum level marks.
(5) If the engine oil level is significantly above
the maximum level mark, consult a
Yamaha dealer. If the engine oil level is
below the minimum level mark, add en-
gine oil.
(6) Loosen the engine oil filler cap and re-
move it.
(7) Slowly add engine oil.
TIP:
The difference between the minimum and
maximum level marks on the dipstick is equal
to approximately 1 L (1.06 US qt, 0.88 Imp. qt)
of engine oil.
(8) Wait approximately 5 minutes to allow the
engine oil to settle, and then check the
engine oil level again.
(9) Repeat steps 3–8 until the engine oil is at
the proper level.
(10)Securely install the engine oil filler cap by
tightening it until it stops.
(11)Securely install the seat in its original po-
sition.
1 Dipstick
1 Maximum level mark
2 Minimum level mark
1
2
1
1 Engine oil filler cap
1
UF2M11E0.book Page 53 Monday, July 11, 2011 10:21 AM