xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
254
DGS-3426:5#create iproute 10.48.74.121/8 10.1.1.255 primary
Command: create iproute 10.48.74.121/8 10.1.1.255 primary
Success.
DGS-3426:5#
delete iproute
Purpose Used to delete an IP route entry from the Switch’s IP routing table.
Syntax
delete iproute [default |<network_address>] <ipaddr>
Description This command is used to delete an existing entry from the Switch’s IP routing table.
Parameters default – Specifies to delete a default IP route entry.
<network_address> − IP address and netmask of the IP interface that is the destination of
the route. The address and mask information can be specified using the traditional format
(for example, 10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/8).
<ipaddr> − The gateway IP address for the next hop router.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To delete a backup static address 10.48.75.121, mask 255.0.0.0 and gateway (ipaddr) entry of 10.1.1.254 from the
routing table:
DGS–3426:5#delete iproute 10.48.74.121/8 10.1.1.254
Command: delete iproute 10.48.74.121/8 10.1.1.254
Success.
DGS–3426:5#
show iproute
Purpose Used to display the Switch’s current IP routing table.
Syntax
show iproute {[<network_address> |<ipaddr>]} {static}
Description This command is used to display the Switch’s current IP routing table.
Parameters
<network_address> − IP address and netmask of the IP interface that is the destination
of the route. The address and mask information can be specified using the traditional
format (for example, 10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/8).
<ipaddr> − Specifies the IP address of the destination of the route.
{static} – Add this parameter to display all statically configured IP routes set on the
switch.
Restrictions None.
Example usage:
To display the contents of the IP routing table:
