xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
36
Command Parameters
delete snmp group <groupname 32>
show snmp groups
create snmp [host <ipaddr> | v6host <ipv6addr>] [v1 | v2c | v3 [noauth_nopriv |
auth_nopriv | auth_priv]] <auth_string 32>
delete snmp [host <ipaddr> | v6host <ipv6addr>]
show snmp host {<ipaddr>}
show snmp v6host {<ipv6addr>}
enable snmp traps
enable snmp authenticate traps
show snmp traps
{ linkchange_traps { ports <portlist>}}
disable snmp traps
disable snmp authenticate traps
config snmp system_contact <sw_contact>
config snmp system_location <sw_location>
config snmp system_name <sw_name>
enable rmon
disable rmon
Each command is listed, in detail, in the following sections.
enable snmp
Purpose Used to enable the SNMP function on the Switch.
Syntax
enable snmp
Description This command is used to enable Simple Network Management Protocol (SNMP) on the
Switch.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To enable SNMP:
DGS–3426:5#enable snmp
Command: enable snmp
Success.
DGS–3426:5#
