12
1995-1997 - INLINE, INC PATHFINDER OPERATION MANUAL - REV2.1A May 19, 1997
The following screen will appear (although it may appear different for your unit if it is already set for a
different Command Code):
The asterisk in 1[]* indicates that this Command Code is currently selected,. To choose a different
Command Code, press the corresponding number button. For example, pressing the number 3 button will
place the asterisk in
3()*, choosing the parenthesis as the Command Code. When the desired Command
Code is chosen, you can select it or exit with no change as follows:
MENU:
Pressing the MENU button exits this section with no change.
ENTER/SELECT:
Pressing the ENTER/SELECT button will temporarily store the Command Code setting until the
power is turned off. Upon re-applying power to the PATHFINDER, the Command Code will return
to its previously saved setting.
SAVE/RECALL:
Pressing the SAVE/RECALL button will save the Command Code setting in memory and will use it
every time the unit is powered on. This setting will remain until you re-program the unit to Save a
different setting or reset the PATHFINDER to Factory Default (see Power On Settings on page 13
for more details).
Show SYSTEM Info:
The Show SYSTEM Info section displays information about your PATHFINDER. Enter this section by
pressing the ENTER/SELECT button when the screen reads as follows:
The following screen will appear (although it may appear different for your unit depending on its
configuration):
The screen above shows that the Firmware version of the unit is 2.0a, and the C/N# tells us that it is a 12 in,
4 out unit. The Configuration Number, C/N#, describes the unit and is set at the factory. Some examples
are as follows:
