14
1995-1997 - INLINE, INC PATHFINDER OPERATION MANUAL - REV2.1A May 19, 1997
Enter this section by pressing the ENTER/SELECT button. The following screen will appear (although it
may be different for your unit):
The screen above shows the boards currently assigned to Group 1. The factory default is to have all six
boards assigned to Group 1, where:
Board # Description
1 Red Video board
2 Green Video board
3 Blue Video board
4 Sync board
5 Left Audio board
6 Right Audio board
To assign different boards to Group 1, simply type the numbers of the boards you would like with the
number buttons. For example, to assign boards 1, 2, 3 and 4 to Group 1, press the number button 1, then 2,
then 3 and then 4. Press the ENTER/SELECT button to confirm, or simply turn the unit off and try again
if you accidentally type in the wrong numbers.
The screen will change to allow you to assign the boards for Group 2. Follow the same procedure until all
boards are assigned to a Group. For example, to assign boards 5 and 6 to Group 2, press the number button
5 and then 6, and confirm with the ENTER/SELECT button.
Each board can be assigned to only one Group. For example, you cannot assign
boards 1, 2, 3 and 4 to Group 1; boards 5 and 6 to Group 2; and boards 1, 2, 3, 4,
5 and 6 to Group 3.
In our example, we are done assigning groups as all 6 boards have been assigned to a group. However, the
PATHFINDER will still prompt you for Groups 3 - 6. Do not assign boards to another Group as this will
cause conflict in the program. Proceed through all other groups by pressing the ENTER/SELECT button.
After Group 6, the unit will save the information and automatically send you into the I/O Config section.
I/O Configuration:
To access the I/O Configuration section, you must hold down the number 3 button while turning the unit on.
The following screen will appear:
