13
1995-1997 - INLINE, INC PATHFINDER OPERATION MANUAL - REV2.1A May 19, 1997
C/N# Model # Description
06140101
IN60016 16 Port Reconfigurable Switcher
06001204
IN61204 12 in, 4 out Fixed Switcher
06000808
IN60808 8 in, 8 out Fixed Switcher
Press any button to exit this section.
POWER-ON ADJUSTMENTS
The PATHFINDER utilizes Power-On adjustments to access critical parameters of the unit. To access a
Power-On adjustment, you must hold down a specific button continuously while turning the unit’s power
switch to "ON" (if power is already on, the user can hold down the indicated button and switch the power
off and then back on.)
Reset to Factory Default:
To reset the unit to the factory default setting, hold down the number 1 button while turning on the unit.
The factory default settings are as follows:
RGB Delay: 0.0 seconds
LCD Contrast: Normal setting
RS-232 Baud Rate 1200
Command Code: [ ]
Board Configuration: Boards 1 - 6 in Group 1
I/O Configuration: 1 input active, 1 output active
Board Configuration:
A PATHFINDER can have up to six boards: red board, green board, blue board, sync board, audio left
board and audio right board. Boards can be assigned as a group and controlled together, with up to six
groups definable by the user. Each group is treated as an independent switcher within the unit, and can even
have its own unique number of Inputs and Outputs. The factory default is to have all boards assigned to
Group 1.
One of the most common uses of assigning multiple groups is to switch audio independent of video. This
can be accomplished by assigning boards 1 to 4 (red, green, blue and sync boards) to Group 1, and boards 5
and 6 (audio left and right boards) to Group 2. Now, Group 1 and Group 2 can be switched independent of
each other.
To access the Board Configuration section, you must hold down the number 2 button while turning the unit
on. The following screen will appear:
