28
■ Basic Operation Flow
System Unit Selection
Monitor Selection
Camera Selection
System Unit
Setup and Operation
Camera setup
and control
System Operation
Login
Logout
Unit selection
Monitor
selection
Camera
selection
Logout at the
end of
operation
Alarm suspension or reset
Operation
(Multiscreen segment
switching and sequence
Operation
(Panning, Tilting,
and zooming, etc.)
Login
■ LCD/BUZZER Adjustment
You can perform the settings of LCD brightness, LCD con-
trast, alarm buzzer, or button buzzer as follows.
1. Press the ADJUST button to select a desired menu.
Every pressing the button will display the brightness
setting menu
→ contrast setting menu → alarm buzzer
setting menu
→ button buzzer setting menu inter-
changeably.
Note: If no adjustment has been performed for 5 sec-
onds or more, these setting menus will automatical-
ly disappear and the LCD will return to the default
status.
2. After adjustment, press the MON (ESC) or EXIT but-
ton.
The LCD display will return to the default status.
● Brightness Level Adjustment
You can change the brightness level by rotating the
JogDial.
Adjust the LCD brightness level while watching the LCD.
Note: 1 (lowest) to 20 (highest) are available. The factory
default is 14.
● Contrast Level Adjustment
You can change the contrast level by rotating the JogDial.
Adjust the contrast level while watching the LCD.
Note: 1 (highest) to 20 (lowest) are available. The factory
default is 9.
● Alarm Buzzer Setting
You can change the duration time of alarm buzzer sound
by rotating the JogDial. Adjust the alarm buzzer setting
while watching the LCD.
Note: OFF, 1s (second), 2s, 3s, 4s, …, 30s, 40s, 50s, and
60s are available. The factory default is 2s.
LCD Bright 14
LCD Contrast 9
Buzzer Alarm 2s
