49
● System Functions (SYS)
System Setup
You will open the setup menu of system unit and change
the settings.
SX150 OSD (WJ-SX150 Series only)
This function is reserved for future use.
VLD History
This function is reserved for future use.
Mux VCR/CAM (Available if Video Multiplexer
WJ-FS416 or Multiplexer Board WJ-SXB151 is
Used in the System)
You can activate either VCR playback or camera picture
display on an active monitor.
Mux Still (Available if Video Multiplexer WJ-
FS416 or Multiplexer Board WJ-SXB151 is
Used in the System)
You can activate either still or moving mode for display on
the multiscreen monitor.
● Controller
Camera Cleaning
You will select the first and last camera channel to perform
camera cleaning.
Time & Date Type
You will set the time and date display pattern of time-and-
date entry form.
Auto Login
You will set operators who can log into the system automati-
cally.
Operator Setup
• You will register a new operator.
• You will change parameters of registered operators.
Function Level
You will change the function levels of operators.
Camera Level
You will change the camera control levels of operators.
Cam Posi Map
You will register camera positions (the association of cam-
era numbers and preset position numbers).
LCD MENU SYS 301
System Setup
LCD MENU CNT 402
Time&Date Type
LCD MENU CNT 403
Auto Login
LCD MENU CNT 404
Operator Setup
LCD MENU CNT 405
Function Level
LCD MENU CNT 406
Camera Level
LCD MENU CNT 407
Cam Posi Map
LCD MENU SYS 302
SX150 OSD
LCD MENU SYS 303
VLD History
LCD MENU SYS 304
Mux VCR/CAM
LCD MENU SYS 305
Mux Still
LCD MENU CNT 401
Camera Cleaning
