6-2
P/N: 4PFX020-020
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
24APR06 v1.1 MusGT(4PFX..020 v1.1)
Fig. 6-g
Fig. 6-h
G. Connect the supplied length of 5/8" hose to
the previously installed 5/8" 90° fitting on
the cast elbow. Trim for best fit and attach to
the stock fitting on the valve cover. (See
Fig. 6-g.)
J. Connect a piece of the supplied vacuum line
to the top of the by-pass valve. Route the
line to the rear of the carburetor enclosure
and attach to the vacuum fitting previously
installed.
H. Connect the factory 3/8" hose with the
check valve (previously connected to factory
carburetor) to the 3/8" 90° fitting installed in
the cast inlet elbow. Route the A/C line
down under the 1" port on the cast inlet
elbow. (See Fig. 6-h.)
I. Attach a piece of the supplied 1"ID rubber
hose approximately 9.5" long to the 1" port
on the cast elbow and secure using a #16
hose clamp. Connect the by-pass valve to
the open end of hose and secure with a #16
hose clamp. Attach a piece of 1"ID rubber
hose approximately 2" long to the open end
of the by-pass valve and secure using a #16
hose clamp. (See Fig. 6-h.)
1" x 9.5"
RUBBER HOSE
A/C LINE
FACTORY 3/8" LINE
WITH CHECK VALVE
BYPASS VALVE
SUPPLIED
5/8" HOSE
VACUUM LINE
CONNECTION
LOWER REAR
1" x 2" RUBBER HOSE
