Remington's SPR 94 Manual

next previous

Instructions For Assembly Of Combination Rifle/Shotgun (cont’d)

3. Holding the barrel assembly with one hand, engage the lower locking lug located on the lower portion of

the barrels with the receiver. The half round cut out on the lower locking lug fits around the round bar in

the forward lower portion of the slot in the receiver. With the barrels engaged into the receiver, swing the

barrels up into the locked position and release the locking lever which should move back to the fully

locked position. (See

Picture 27).

4. Now that the barrels have been locked into the receiver, you must reattach the forend to the barrels. Place

the forend on the front curve of the receiver (the angle between the forend and barrels should be able 20

degrees). Keep contact between forend and receiver with an upward swinging motion and lock the forend

into the barrels. (See

Picture 28). While it may be necessary to push the latch into its final flat

position, never force the latch into position.

5. Make sure the trigger block safety is in the “ON” or “SAFE” position after completion of assembly.

(See

Picture 29).

Picture 27

Picture 28

Picture 29