Filter
Top Products
Customizing set-up parameters in DMS
Saving and sending/setting configurations
053-644, Rev H Page 30 eg4
30
Saving and sending/setting configurations
With the Edge, there are saved setup profiles used to quickly access and apply to The Edge(s). Below
explains how to save configuration settings in DMS and how to send/set to the instrument. Note: if you
wish to only send the setup, please skip to step 3. Please refer to this section as you setup your
instrument.
1. To save the Edge configuration in the software, click on a name in the Configuration Profile
Management panel (See 1). Note: The name will be shaded a light gray when selected.
• To create a new profile name, click and type in a profile name. Click Save. (It will save
under the configuration profile management panel).
2. Click on the button (see 2) and type in a Name. Click Ok.
• Note: This saves the configuration file in the software.
• Or click button and rename the setting by typing in a name. Click Ok.
3. To send to the instrument, select the (see 3).
Figure 3-11: Saving and sending Edge setups
2
3
1