Filter
Top Products
E SPOT LED™
©Elation Professional, Los Angeles Ca. 19 www.ElationLighting.com
8. FIXTURE MENU
On-Board System Menu: The E Spot Led
™
comes with an easy to navigate system menu.
This next section will detail the functions of each command in the system menu.
LCD Control Panel: The control panel located on the base of the fixture allows you to
access the main menu and make all necessary adjustments to the E Spot Led™. During
normal operation, tapping the “Mode/Esc” key once will access the fixture’s main menu.
Once in the main menu you can navigate through the different functions and access the
sub-menus with the Up and Down buttons. Once you reach a field that requires adjusting,
tap the ENTER button to activate that field and use the UP and Down button to adjust the
field. Tapping the Enter button once more will confirm your setting. Once a setting is saved
the display will briefly readout OK to confirm a new setting has been made and locked into
memory. You may exit the main menu at any time without making any adjustments by
tapping the Mode/Esc button.
MODE/ESC Button - To access the main menu locate the Mode/Esc button on the front of
the unit. Press this button to activate the system menu. Tap the UP button until you reach
the function you wish to change. When you reach the function you wish to change tap the
ENTER button once to select that menu function. When a function is selected use either the
UP or DOWN buttons to change the function. Once your changes are made tap the ENTER
button yet again to lock the change in the system menu. To exit without making any
changes tap the Mode/Esc button.
Default settings shaded.
0
ADDR
AXXX A001
Indicate the staring DMX address
A001 also is the setting for slave
1
TEST
T-01~T-XX
Automatically test the function
RUN
MSTR/ALON
Runs fixture as “master” or “alone” for
auto
AUDI
MSTR/ALON
Runs fixture as “master” or “alone” for
audio
2
PLAY
AUTO
Clos/Hold/Auto/Audi
No DMX Status
ALL
Reset all motors and returns fixture to
home
SCAN
Reset only motors for pan/tilt
3
RESE
COLR
Reset only motors for colors