Filter
Top Products
22
CAUTION: Ensure that the settings to be loaded are compatible with this NavNet unit.
Improper settings will damage the equipment.
7. The screen for set up of units of measurement appears.
RANGE UNIT
nm, kt
DEPTH UNIT
ft
TEMPERATURE UNIT
°F
WIND UNIT
kt
LOCAL TIME OFFSET
+00:00
AIR PRESSURE UNIT
hpa
Installation wizard, units of measurement
8. Choose an item and then press the EDIT soft key. One of the following windows
appears.
RANGE/SPEED UNIT
▲
{ nm, kt
~ km, km/h
{ sm, mph
{ nm & yd, kt
{ nm & m, kt
{ km & m, km/h
{ sm & yd, mph
▼
DEPTH UNIT
▲
{ m
~ ft
{ fa
{ PB
▼
TEMPERATURE UNIT
▲
{
°
C
~
°
F
▼
WIND UNIT
▲
{ kt
~ km/h
{ MPH
{ m/s
▼
LOCAL TIME OFFSET
+ 0 0:00
AIR PRESSURE UNIT
▲
{
hpa
~
mbar
{
mmHg
{
inHg
▼
9. Choose unit of measurement desired and then press the ENTER soft key. LOCAL TIME
OFFSET allows you to use local time (instead of UTC time). Set the time difference
between local time and UTC time.
10. After you have chosen units of measurement, press the NEXT soft key, and the
NETWORK SETUP menu appears. This is where you set up your NavNet network. See
the illustration on then next page for typical network setup. If you have no other
NavNet devices installed, press the NEXT key and go to step 13.
DEVICE NUMBER
1
(HOST NAME NAVNET1)
(IP ADDRESS 172.031.003.003)
RADAR SOURCE
1
SOUNDER SOURCE
ETR0
FOR FURTHER DETAILS,
PLEASE REFER TO THE
INSTALLATION MANUAL
Installation wizard, network setup