Filter
Top Products
30
GPS SETUP menu description (con’t from previous page)
Item Description Settings Default Setting
Fix Mode
Choose position fixing method: 2D
(three satellites in view), 2D/3D (three
or four satellites in view whichever is
greater).
2D, 2D/3D 2D/3D
Cold Start
Clears the Almanac to receive the latest
Almanac.
No, Yes No
WAAS setup
Press the WAAS SETUP soft key at the GPS SETUP menu to show the WAAS SETUP
display.
Contents of WAAS SETUP menu
Item Description Settings Default Setting
WAAS Mode Select ON to use the WAAS mode. On, Off Off
WAAS
Search
WAAS satellite can be searched
automatically or manually. For manual
search, enter appropriate WAAS satellite
number.
Auto, Manual Auto
WAAS Alarm When the WAAS signal is lost, the
audible alarm sounds with the visual
message “NO WAAS SIGNAL.”
On: Alarm continues to sound until the
WAAS positioning mode is available
again or the alarm is recognized by key
operation.
Off: Alarm sounds three times.
On, Off Off
Corrections
Data
Selects the type of message for WAAS
correction. Use “00” (operational status)
in North America; “02” in other locations.
00 to 27, 99 02
31. After you have finished setting up the GPS receiver GP-320B/330B, it’s now time to set
up external equipment. Press the NEXT soft key to show the DATA1 (GPS/NMEA) port
setup menu. It is only necessary to set up ports which you are going to use; skip
unnecessary steps. If you do not have external equipment connected to the NavNet,
press the NEXT key several times to show the “FINISH AND EXIT INSTALLATION
WIZARD” screen and then push the ENTER knob to finish.
OUTPUT FORMAT
NMEA0183 2.0
BAUD RATE
4800bps
LAT/LON FORMAT
DD°MM.MMM'
XTE FORMAT
X. XX
OUTPUT DESTINATION
NO
Installation wizard, DATA1 (GPS/NMEA) port setup menu