Filter
Top Products
1. MOUNTING
1-17
1. Prepare a cutout in the mounting location as shown in the figure below.
388 150±2
170±2 176±2
±2
For RCU-020 For RCU-015FEA and RCU-016
2. Set the control unit to the cutout.
3. Attach the mounting plate to the control unit with four screws from the rear side.
4. Screw the wing screw to each mounting plate and then insert hex bolt to each wing
screw.
5. Fasten each wing screw and then fasten the hex nuts as shown in the figure below.
(P)
#70
53
92
(P)
#70
171
53
86
Note: P 10
<
=
RCU-020 RCU-015FEA/RCU-016
To connect RCU-016 in series with RCU-020
1. Pass the cable derived from RCU-016.
2. Connect the connector
of the cable to J502.
3. Clamp the copper part of the cable with the cable clamp.
Inside of RCU-020