Filter
Top Products
3. SETTING AND ADJUSTMENT
3-14
Blind Sector 1 and Blind Sector 2
Set area (up to 2) where no radar pulses will be transmitted. For example, set the area
where an interfering object at the rear of the scanner would produce a dead sector (area
where no echoes appear) on the display. To enter an area, enter start bearing relative the
heading and dead sector angle. To erase the area, enter 0 for both the START and ANGLE
sections. The setting range of START is 0 to 359° and ANGLE is 0 to 180°.
Note: The blind sector setting should be done after the heading alignment (see section 3.5).
Antenna Revol.
This menu item is used for 42 rpm antenna unit. The default is AUTO, where antenna
revolution speed is high for short range setting and low speed for long range setting. When
LO is selected, the antenna always rotate in 36 rpm, and HI, 42 rpm.
Antenna SW and Antenna Stopd
This is used for antenna maintenance by serviceman.
INSTALLATION menu setting
Open the Installation menu by clicking “Page 2” tab on the “Radar Initialize” menu.
Radar MAIN TOP
Model 25 DOWN
Radar Initialize