Filter
Top Products
9
3.2 Mounting the Display Unit/Sub-display Unit
The display unit/sub-display unit is designed for tabletop mounting. When selecting as mount-
ing location consider the following conditions:
• Place where operating personnel are able to control the unit easily while observing the fish-
ing ground or the area surrounding the vessel.
• Place at least 1 m away from a magnetic compass and components which have a magnet
(radar magnetron, loudspeaker, high power transformer, etc.)
• Place not exposed to direct sunlight, water splashes or hot
air.
• Place where maintenance and ventilation clearance shown
in the outline drawings is ensured.
• Place where the CRT face is within ±45° from vertical.
Mounting the display unit/sub-display unit
1. Remove the mounting base by unscrewing the two bolts at
the front bottom.
2. Fix the mounting base to the table with four M10 bolts, flat
washers, spring washers and nuts. It is recommended that a
rubber mat be placed under the mounting base to absorb
vibration.
3. Fasten the unit to the mounting base with two bolts. When
the space around the unit is limited, make wirings to the
display unit first and then fasten the unit.
Note: For the CSH-24, remove eye bolts at the top of the dis-
play unit and set cosmetic screws (supplied with installation
materials) to eye bolt holes.
Figure 3-10 Mounting the display unit,
sub-display unit