Filter
Top Products
1. INSTALLATION
1-14
IEC61162: Transmit and receive IEC61162 format data via COM port. (P-sen-
tences are received but not transmitted. P-sentence is FURUNO’s original sen-
tence.)
IEC61162+P-sentence: Transmit and receive IEC61162+P sentences format
data via COM port.
Off: FA-50 transmits no data from COM port.
With the radio buttons at RX Speed, choose how RX speed is regulated, Auto or
Manual. For manual, choose speed from the drop-down list.
Note: Tx speed is fixed at 38400 bps.
3. Click OK to confirm setting.
NETWORK setup
If connected to a LAN (via NETWORK port), set the IP address for FA-50 as shown
below.
1. Click Network Setup to show the Network Setup screen.
2. Enter the IP address assigned to the FA-50.
3. Enter subnet mask for the network.
4. Enter gateway address.
5. For NavNet connection, enter NavNet port number at NavNet Port Number. Enter
ten-thousandths and one-thousandths places.
6. At Host Name, select host name to be used in NavNet, AIS0 - AIS9, from the win-
dow.
7. At Host Name, enter host name to be used in NavNet, AIS0 - AIS9.
Auto: Auto-detect of where to output AIS data.
Continuous AIS: Output AIS data continuously.
Continuous GPS: Output GPS data (L/L, SOG, COG) continuously.
Continuous ZDA: Output time data continuously.
Continuous AIS/GPS: Output AIS/GPS data continuously.
Continuous AIS/ZDA: Output AIS/time data continuously.