Filter
Top Products
16
Installation of DGPS receiver
Procedure
1. Disconnect 8P connector as shown in the figure below.
A
View
PH8P
J106
(P) MAIN
PANEL ASSEMBLY
CHASSIS ASSEMBLY
CONNECTOR
A
Figure 4-2 Dismounting chassis assembly
2. Dismount chassis assembly from panel assembly by disconnect-
ing connector shown in the figure above.
3. Cut the cable ties as shown in the figure below.
Cut cable tie.
ANLG board
Cut cable tie.
J8
GN-7707
Figure 4-3 Cutting cable ties
4. Dismount heat sink from chassis assembly by unfastening four
screws on the ANLG board and disconnecting the connector of
the mini pin coaxial cable.
Handling of Coaxial Cable
• Do not touch the connector with bare hands;
use gloves.
• Use radio pincers to remove, and pull out
straightly.
• Plug in connector straightly.